EASILY REPLACE YOUR ZONEPRO BANNER

BANNER REPLACEMENT GUIDE

Watch the video or read the written instructions below to learn how to replace the Banner in your ZonePro Canister.


TOOLS NEEDED:

PHILLIPS HEAD SCREWDRIVER

STEP ONE

Set up by laying the ZonePro and new fabric cartridge flat on a table or other flat surface.

STEP TWO

Unscrew the bottom cap (the cap with the "23 winds" sticker).


This is the side that has the tension with the spring, so be careful when you pull the cap out not to let the cap unwind too quickly.



STEP three

Remove the Cap and the spring assembly (it is all one piece).


A) You can leave the screws in place inside the cap

B) Set the spring assembly to the side



STEP FOUR

Pull out the old fabric cartridge.


Be sure to remember how the fabric was oriented so you can put the new fabric in the same way.



STEP FIVE

Make sure to keep upper plastic spool to use with the new fabric.


The plastic spool will either be attached to the end of the fabric cartridge or you will need to tip the ZonePro, so it falls out.

STEP SIX

Insert hardware into new fabric cartridge.


Then, insert the spring assembly into the new fabric cartridge 

(it only fits in one way).




STEP SEVEN

Next, insert the plastic spool in the new fabric cartridge 

(it only fits in one way).

STEP EIGHT

Insert the new fabric into the ZonePro case.


Be sure to put it in with the fabric facing the same way as the old spindle you pulled out.

STEP NINE

Rotate the cap 23 winds in the direction of the arrow.



STEP TEN

Push the cap back into place and tighten the screws.


NOW YOU ARE DONE!



Still need help? Call us 989-966-3776 or email us at support@zonepro.com

NEED HELP WITH A CUSTOM ORDER?

Do you need help with a custom order or have a specific request that requires direct assistance? If so, please don't hesitate to get in touch. We are happy to assist you.